Advantec Products
Walk-in Fume Hoods

Available in :
- WIDTH: 1600 mm (63") or 1900 mm (74 13/16")
- DEPTH : 940 mm (37")  
- HEIGHT:  2800 mm (110 1/4")

Features: 
- Exterior shell constructed of cold sheet steel with a polyvinyl chloride coating (fireproof)
- Exterior front column removable for access to fixtures 
- Exhaust duct collar 250 mm ID  
- Interior lining (wall) including baffle of polyester, reinforced with fibre glass
- Interior molded without any seams as one solid piece
- Corners are rounded in order to favour the perfect laminar air flow (according to BS 3532 and BS 3953 Standards)
- Cabin fixed to a stainless steel AISI 304 quality grade structure that gives it its extreme rigidity
- Two tube fluorescent light fixture pre wired to generate 500 lux minimum on work surface

- Without worktop 
- 6 mm (1/4") thick tempered framed safety glass sash with combination of 4 sliding glass sashes. Safety sash counter balance system to retain the full weight of the counter weight in the event of cable breakage. 
- Safety monitor composed by : 
   * light switch
   * exhaust fan switch
   * airflow controller with visual ands accoustical alarm
   * over sash opening controller with visual alarm
   * connector RS-232 type for parameters programming
   * over temperature alarm with automatic extraction cut off
- Cupsink, service fixtures and electrical receptacles are integrated on the right side of the fume hood. Possibility for up to 5 service fixtures (please contact us to define type and quantity)  
- Standard service fixtures: 1 pre-plumbed remotely controlled water service fixture (please contact us to define other service fixtures) 
- Standard electrical receptacles: 2 pre-wired electrical receptacles (please contact us for additional electrical receptacles) 
- For the carrying out of chemical engineering assemblies, this fume hood can be equipped with a stainless steel scaffolding
   
Source: http://www.floresvalles.com